Easier Approach to Electronic Projects

LED Dimmer


The circuit which i found initially had 50k potentiometer, but the one i have used is 10k and it worked fine with that. The code for the 100nF capacitor is “104” so any capacitor which has this code is to be used in this circuit. You must use a Bright LED for this, buy the one of a very good quality. 

Parts List:

  1. 1k & 390ohm
  2. 50k potentiometer
  3. 100nf x (2)
  4. 1N4148 x (2)
  5. Bright LED
  6. 555 Timer
  7. 9v Battery
   

 




NOTE: In the Circuit Diagram. There are two pin no 3s in 555 Timer IC. The pin no 3 which is connected to ground is actually pin no 1. 

 

Bread Board Arrangement:

                

%d bloggers like this:
Read more:
Random LED Flasher

This Project flashes 8 LEDs in random manner   The speed of random flashes can be changed by simply changing...

Intro to Fritzing

Fritzing is an open-source wonderful software for artists, researchers and hobbyists to work creatively with interactive Electronics. It is developed at...

Controlling DC Motor using Arduino

This is actually controlling speed of DC motor with potentiometer using  Arduino, where DC motor is supplied by PWM output...

Close